C1725 on Ford: How to Diagnose & Fix
Steering Torque Sensor Circuit
1 Ford model · 2 documented issues · $200-$1,500 repair
C1725 on Ford by model: symptoms, diagnosis and fix
The 2003-2017 Ford Expedition with optional air suspension (standard on Eddie Bauer, King Ranch, Platinum, and EL/MAX trims) suffers from air suspension compressor failure, air spring leaks, and ride height sensor malfunctions. The compressor, located under the vehicle, is exposed to road debris, salt, and moisture which degrades the motor and valves. When air springs develop leaks, the compressor runs continuously trying to maintain ride height, leading to premature burnout. RepairPal estimates compressor replacement between $666 and $724, though dealer pricing can reach $1,200. NHTSA has received hundreds of complaints regarding air suspension failures. Strutmasters.com notes that 2007-2011 Expedition and Navigator share the same air suspension system and failure patterns. Many owners opt for air-to-coil spring conversion kits as a permanent, lower-cost solution.
Common Symptoms
- Rear of vehicle sagging or sitting noticeably lower
- Air suspension warning light or message on dash
- Compressor runs excessively or continuously
- Loud compressor noise from under the vehicle
- Harsh ride over bumps
- Vehicle leans to one side
- Hissing sound from air springs or compressor
- Vehicle bottoming out on speed bumps or driveway transitions
How to Fix
Most cost-effective permanent fix is an air-to-coil spring conversion kit from Strutmasters or Arnott ($300-500 for kit plus installation). If keeping air suspension: replace the compressor (Arnott P-2936 or Dorman 949-200, $200-400 part), both rear air springs ($150-250 each), and inspect all air lines for cracks. Always replace air springs in pairs. Compressor relay should also be checked - a corroded relay causes intermittent compressor operation. RepairPal estimates $666-724 for compressor replacement at a shop.
Sources for this issue (1)
Expeditions equipped with the rear air suspension system experience compressor failure, causing the rear of the vehicle to sag. The compressor wears out from overwork — it cycles frequently due to slow air leaks in the air springs (bags) and supply lines. When the compressor fails, the rear drops to the bump stops, creating a nose-up stance and poor ride quality. The air springs themselves develop dry rot cracks and leak, particularly in dry or hot climates.
Common Symptoms
- Rear of vehicle sagging or sitting low
- Compressor runs constantly or makes loud noise
- Suspension warning message on dashboard
- Rear bounces excessively over bumps
- Vehicle leans to one side in rear
How to Fix
Replace the air suspension compressor ($150-300 for aftermarket, $200-400 OEM). Simultaneously inspect and replace any leaking air springs ($100-200 each, two required). Total repair to restore the air system: $500-1,200. Many owners convert to conventional coil springs using a conversion kit ($200-400) from Strutmasters or Arnott, which eliminates the air system entirely and requires no future maintenance.
Sources for this issue (1)
C1725 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does C1725 mean on a Ford?
C1725 stands for "Steering Torque Sensor Circuit." C1725 is a chassis code indicating the control module has detected a problem in the steering torque sensor circuit. The steering torque sensor measures how much twisting force you apply to the steering wheel and feeds that signal to the electric power steering (EPS) or stability/4WD system so it can deliver the right amount of assist. When the sensor's signal is missing, out of range, or electrically faulty, the module sets this code. You may notice heavier or inconsistent steering effort and a warning light, since the system can reduce or disable power assist as a precaution. On Ford it is documented across 1 model: Expedition.
What are the most common causes of C1725?
The most common causes of C1725 are: Faulty steering torque (torque/angle) sensor, Damaged wiring or connector in the sensor circuit, Corroded or loose connector at the steering column, Open, short, or chafed wire in the harness, Failed power steering / EPS control module, Low system voltage or poor ground, Recent steering or clockspring service not properly calibrated. The specific cause varies by vehicle.
How much does it cost to fix C1725 on a Ford?
Published repair estimates on Ford range from $200 to $1,500 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for C1725 on a different make?
View C1725 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.