P0441 on Dodge: How to Diagnose & Fix

AC compressor fails due to inadequate lubrication, leaky seals, and internal mechanical failure. Evaporator develops leaks from age and moisture. Condenser prone to damage from road debris. Lack of lubrication from leaks causes compressor seizure.

Many Challenger owners report that the fuel tank is hard to fill and the gas pump nozzle clicks off (shuts off) repeatedly before the tank is full, often with fuel backing up or spitting out of the filler neck. RepairPal lists this as one of the most-reported Challenger problems, with a dedicated problem page; in their data the complaints were concentrated on the 2008-2009 cars (5 owners reporting, around 65,000 miles average), but owner forums (ChallengerTalk, Hellcat.org) show the same premature-shutoff complaint persisting across later SXT, R/T, Scat Pack and SRT Hellcat models. The root cause is the EVAP (evaporative emissions) venting path that is supposed to let air/vapor escape the tank as fuel goes in. When that path is restricted, displaced vapor cannot vent, tank pressure rises, fuel backs up into the filler neck, and the nozzle's automatic shutoff senses 'full' prematurely. Specific culprits identified by RepairPal and dealer/diagnostic sources include a restricted or kinked vapor recirculation tube, a faulty fuel fill (filler) tube, a clogged EVAP fresh-air filter or vent line, and a malfunctioning EVAP canister vent/control valve. RepairPal also documents a saddle-style (two-half) tank design on some cars where an internal fuel-distribution/overfill mechanism malfunctions and trips the overfill sensor early, in which case the cure was a complete fuel tank replacement. On modern cars the same symptom frequently appears alongside EVAP fault codes (P0440, P0441, P0452), and a stuck or restricted purge/vent path is the first thing to check. The issue is overwhelmingly a fueling-station annoyance and slow-fill nuisance rather than a safety or driveability defect, which is why it rates LOW severity, though it is highly searchable because so many owners hit it at the pump.

A very common and frequently misdiagnosed problem on the Dodge Charger is failure of the EVAP (evaporative emissions) leak-detection device, which causes the PCM to log P0456 (small EVAP leak), P0455 (large EVAP leak), and/or P0457 (leak detected / fuel cap loose) and illuminate the check-engine light. On 2011-and-newer Chargers the system uses an ESIM (Evaporative System Integrity Module) — a natural-vacuum-based switch (the same NVLD-style monitoring concept) mounted directly on the charcoal/EVAP canister behind the passenger-side rear wheel well. With the EVAP system sealed, the PCM watches the ESIM/NVLD switch; if the switch's internal mechanical diaphragm fails or its external O-ring seal degrades, the switch fails to close within the calibrated time and the PCM falsely reports an EVAP leak. The classic giveaway is that a smoke test shows NO actual leak yet the code keeps returning. Because the code is almost always assumed to be a loose or failed gas cap, owners (and shops) often chase the wrong part first — replacing the gas cap and purge valve before discovering the real culprit is the inexpensive ESIM module. The code is low-severity (no driveability or engine damage, only a slight fuel-economy effect) but will fail an emissions/smog test and leaves the CEL on. In a worst-case escalation, the same codes can be caused by a pinhole leak on top of the fuel tank near a fuel-pump lock ring, which requires fuel-tank replacement. On 2022+ cars, Mopar TSB 18-094-23 addresses an over-sensitive EVAP monitor that can falsely set P0455/P0456/P0440/P0441 and is corrected with a PCM software update rather than a part.