P0ACE on Ford: How to Diagnose & Fix
Hybrid Battery Temperature Sensor "C" Circuit Intermittent/Erratic
1 Ford model · 1 documented issue · 1 critical · $400-$1,100 repair
P0ACE on Ford by model: symptoms, diagnosis and fix
The first-generation Escape Hybrid uses a dedicated electric coolant pump (the Motor Electronics Coolant System, or MECS, pump) to circulate coolant through the traction inverter and DC/DC converter — a loop entirely separate from the gasoline engine's cooling system. The brushed pump motor wears out and the pump stops circulating, so the inverter power electronics overheat. The hybrid control system responds by throwing a red-triangle warning and a "Stop Safely Now" message, which derates and then disables the vehicle, often at highway speed. Failures are typically intermittent first — the vehicle restarts and drives normally for days — before the pump quits entirely. Owners on escape-city and Ford forums report the failures beginning in the 50,000-mile range and repeating on a second pump. Because the loop is separate from the engine, the temperature gauge reads normal throughout and the engine never overheats, which sends many owners and shops down the wrong diagnostic path. Ford TSB 08-24-5 covers a related overheat pattern on 2005-2008 Escape Hybrid and 2006-2008 Mariner Hybrid. This is a hybrid-only failure on the 2.3L Atkinson hybrid powertrain; it does not exist on the conventional 2.3L or 3.0L Escapes.
Common Symptoms
- Red triangle warning light and "Stop Safely Now" message on the dash
- Vehicle derates then loses motive power, sometimes at speed
- Engine temperature gauge reads normal the entire time
- Overheat codes for the inverter / motor electronics
- Intermittent at first — restarts and drives fine, then recurs
- No audible pump hum from the auxiliary pump with the vehicle in Ready mode
How to Fix
Replace the MECS/inverter coolant pump and refill and bleed the hybrid electronics coolant loop with the correct specification coolant — bleeding is critical, because trapped air will re-trigger the overheat codes even with a new pump. Verify the loop's own reservoir level (separate from the engine reservoir) and inspect the inverter cooler for restriction, because a partially blocked cooler kills the replacement pump too. Check for chafed or corroded pump connector wiring before condemning the pump; an intermittent connector produces identical symptoms. There is no recall covering this — it is a wear-out item and is customer-pay outside the hybrid component warranty. Ford TSB 08-24-5 addresses the related transaxle/electronics overtemp warning pattern.
Sources for this issue (3)
P0ACE code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0ACE mean on a Ford?
P0ACE stands for "Hybrid Battery Temperature Sensor "C" Circuit Intermittent/Erratic." An intermittent/erratic fault in hybrid battery temperature sensor 'C' circuit. On Ford it is documented across 1 model: Escape.
What are the most common causes of P0ACE?
The most common causes of P0ACE are: Loose/corroded connector, Intermittent wiring, Marginal sensor, BMS fault. The specific cause varies by vehicle.
How much does it cost to fix P0ACE on a Ford?
Published repair estimates on Ford range from $400 to $1,100 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for P0ACE on a different make?
View P0ACE across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.