B1483 on 2006-2017 Hyundai Accent — Driver Airbag Resistance Circuit Short to Ground (2nd stage)
1 vehicles · 1 makes · $250-$2,400 repair
How to diagnose and fix B1483: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Hyundai Accent · 2006–2017
The occupant classification sensor mat built into the front passenger seat cushion fails internally - the printed pressure-sensing traces crack with repeated loading. The car then either lights the SRS/airbag warning lamp with an OCS fault stored, or leaves the PASSENGER AIRBAG OFF indicator lit with an adult sitting in the seat, meaning the passenger airbag will not deploy in a crash. It affects MC (2006-2011) Accents heavily and continues on later cars, and it is well documented across Hyundai/Kia models generally. The financial sting is that Hyundai does not sell the mat separately - the fix is the entire lower seat cushion assembly, and forum owners have posted dealer quotes in the $1,200-$2,400 range for what is a failed sensor pad.
Common Symptoms
- SRS/airbag warning light stays on
- PASSENGER AIRBAG OFF light stays lit with an adult in the seat
- Airbag light comes on only when someone sits in the passenger seat
- Intermittent light that changes with seat load
How to Fix
Pull the SRS codes with a scanner that reads airbag modules (a generic OBD-II reader will not show them). First inspect the connectors under the passenger seat for corrosion, a partially seated plug, or a chafed harness from the seat rails - loose connections cause the same fault and cost nothing. If the mat itself is bad, the OEM route is a passenger seat cushion assembly replacement plus an OCS calibration/zeroing procedure at the dealer. Far cheaper alternatives owners use: an aftermarket replacement sensor mat/bypass emulator, or sending the seat cushion out to a sensor rebuild service. After any repair the OCS system must be recalibrated or the light returns.
Sources for this issue (3)
Find B1483 by make
Browse every documented model and issue for your make.
B1483 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does B1483 mean?
B1483 stands for "Driver Airbag Resistance Circuit Short to Ground (2nd stage)." The Airbag Control Unit (ACU/SRSCM) measures the resistance of each squib firing loop. B1483 sets when the second-stage (dual-stage) driver front airbag inflator circuit measures a short to ground. Hyundai lists this code as one of a defined set that qualifies a vehicle for ACU replacement, indicating the fault is diagnosed as internal to the control unit rather than in the airbag or wiring, and the remedy in the bulletin is to replace the ACU.
What are the most common causes of B1483?
The most common causes of B1483 are: Internal fault in the Airbag Control Unit (ACU/SRSCM) — the remedy Hyundai specifies in TSB 24-BE-014H is ACU replacement, Short to ground in the driver airbag second-stage squib circuit wiring, Damaged clock spring / steering column wiring harness, Corroded or damaged driver airbag inflator connector. The specific cause varies by vehicle.
How much does it cost to fix B1483?
Repair costs for B1483 range from $250 to $2,400, depending on the vehicle and root cause.
Which vehicles are affected by B1483?
Au7o has documented B1483 across 1 vehicle models from 1 manufacturers: Hyundai.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.