P0191 on Genesis: How to Diagnose & Fix
Fuel Rail Pressure Sensor Circuit Range/Performance
1 Genesis model · 1 documented issue · 1 critical
P0191 on Genesis by model: symptoms, diagnosis and fix
The fuel control valve inside the high-pressure fuel pump (HPFP) can let excess fuel into the pump as its plunger gradually wears, producing an air/fuel mixture that runs too rich. This causes a reduction or loss of motive power at low speeds, rough running, and check-engine warnings — increasing crash risk. Genesis recalled certain 2019-2023 G70 vehicles with the 2.0L turbocharged engine under NHTSA campaign 24V-528 (Genesis recall 023G); owner letters mailed September 2024. Many owners also reported the symptom (hesitation/near-stall when driving off within ~30 seconds of a cold start) before the formal recall. The remedy is an ECM software update, with the HPFP also replaced if the check-engine light is already on, performed free of charge under the recall.
Common Symptoms
- Loss of power or hesitation accelerating from a stop or at low speed
- Engine wants to stall if you drive off within ~30 seconds of starting
- Rough running / engine surging
- Check engine light, sometimes with a fuel-rail-pressure code
- Long crank or hard start
How to Fix
First verify the VIN against Recall 24V-528 (023G) — the fix is free under recall. Dealers apply an updated ECM/engine-control software calibration and replace the high-pressure fuel pump if the check-engine light is already on; the remedy pump has an updated fuel-control-valve plunger design. Out of warranty/recall, the OEM HPFP is replaced; the recall lists G70 2.0T pumps 35320-2CTB0 and 35320-2CTB1. After replacement, clear codes and confirm fuel-rail pressure is within spec.
Sources for this issue (1)
P0191 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0191 mean on a Genesis?
P0191 stands for "Fuel Rail Pressure Sensor Circuit Range/Performance." This code sets when the fuel rail pressure sensor's signal is out of its expected range or doesn't match what the computer expects for current conditions. On direct-injection and many modern engines, this sensor reports fuel pressure in the rail so the computer can precisely control fueling and the fuel pump. When the reading is implausible — too steady, erratic, or inconsistent with commanded pressure — this code is set, sometimes with hard starting, hesitation, or reduced power. It generally points to the sensor or its wiring, though an actual fuel-pressure problem can also trigger it. On Genesis it is documented across 1 model: G70.
What are the most common causes of P0191?
The most common causes of P0191 are: Faulty fuel rail pressure sensor, Corroded, loose, or damaged sensor connector, Open, shorted, or high-resistance sensor wiring, Actual fuel pressure out of range (weak pump or regulator), Restricted fuel filter or supply line, Loss of reference voltage or ground from the ECM/PCM, Faulty fuel pressure regulator or control valve. The specific cause varies by vehicle.
How much does it cost to fix P0191 on a Genesis?
Repair costs vary widely with the root cause and Genesis model; each issue on this page carries its own estimate where one is published.
Looking for P0191 on a different make?
View P0191 across all makes →Join 700+ subscribers following Au7o for vehicle insights and updates.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.