P0441 on Chrysler: How to Diagnose & Fix
Evaporative Emission Control System Incorrect Purge Flow
1 Chrysler model · 1 documented issue · $20-$500 repair
P0441 on Chrysler by model: symptoms, diagnosis and fix
Evaporative emission control system develops small leaks triggering P0456 code. Most commonly failed gas cap, chaffed EVAP purge pipe harness, or failed purge solenoid. Triggers check engine light and prevents emissions testing pass.
Common Symptoms
- Check engine light with P0456 code
- "Gas cap" warning even with cap tight
- Fuel smell near vehicle
- Failed emissions test
- No performance or drivability issues
How to Fix
Start with gas cap replacement ($20-40). If code returns, smoke test EVAP system to locate leak. Common fixes: replace purge solenoid, repair chaffed wiring harness, or replace cracked EVAP hoses.
Sources for this issue (1)
P0441 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0441 mean on a Chrysler?
P0441 stands for "Evaporative Emission Control System Incorrect Purge Flow." This code means the Engine Control Module (ECM) detected an incorrect amount of purge flow in the Evaporative Emission Control (EVAP) system. The EVAP system captures gasoline vapors from the fuel tank in a charcoal canister and then 'purges' them into the engine to be burned, controlled by a purge valve. P0441 sets when the computer commands the purge valve open or closed but sees the wrong flow — too much, too little, or none at the wrong time. It is an emissions/sealing issue, not something that usually affects driving, though you may notice a fuel smell. On Chrysler it is documented across 1 model: 300.
What are the most common causes of P0441?
The most common causes of P0441 are: Stuck-open or stuck-closed EVAP purge valve/solenoid, Failed or stuck EVAP vent valve, Loose, damaged, or missing gas cap, Cracked or disconnected EVAP/purge vacuum hoses, Faulty purge flow or pressure sensor, Clogged or saturated charcoal canister, Wiring or connector fault to the purge valve. The specific cause varies by vehicle.
How much does it cost to fix P0441 on a Chrysler?
Published repair estimates on Chrysler range from $20 to $500 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for P0441 on a different make?
View P0441 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.