P0718 on 2005-2011 Mercedes-Benz SLK/SLC (SLK280, SLK300, SLK350, SLK55 AMG) — Input/Turbine Speed Sensor Circuit Intermittent
1 vehicles · 1 makes · $500-$2,200 repair
How to diagnose and fix P0718: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Mercedes-Benz SLK/SLC · 2005–2011
The electronic conductor plate integrated into the 722.9 7-speed automatic's valve body (which houses the internal TCM, speed sensors and shift solenoids) is a widely reported failure on R171 SLKs equipped with the 7G-Tronic. As the plate's internal speed sensors and soldered joints degrade with heat cycling, the transmission drops into limp mode, typically locking into a single forward gear (often 2nd). The condition is temperature-sensitive and commonly appears from roughly 50,000-90,000 miles.
Common Symptoms
- Transmission stuck in gear (often 2nd), won't shift up
- Limp mode / reduced speed limited to ~40 mph
- Harsh or delayed shifts, especially when cold
- Intermittent faults that come and go with temperature
- Speed-sensor fault codes
How to Fix
Replace or rebuild the conductor plate (the revised design), refresh the valve body, and perform a transmission fluid and filter service plus an adaptation reset. Independent specialists offer a cheaper conductor-plate reman as an alternative to Mercedes' full valve-body replacement (roughly $2,000-$3,000 at a dealer). A neglected fluid service accelerates the failure, so periodic 722.9 fluid changes are recommended.
Sources for this issue (3)
Find P0718 by make
Browse every documented model and issue for your make.
P0718 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0718 mean?
P0718 stands for "Input/Turbine Speed Sensor Circuit Intermittent." Set when the input/turbine speed sensor signal is intermittent — dropping out or spiking erratically rather than being continuously absent. Usually indicates a marginal sensor or loose wiring.
What are the most common causes of P0718?
The most common causes of P0718 are: Intermittent open/short in sensor wiring, Loose or corroded connector, Failing input/turbine speed sensor, Debris intermittently affecting signal, Vibration-related harness fault. The specific cause varies by vehicle.
How much does it cost to fix P0718?
Repair costs for P0718 range from $500 to $2,200, depending on the vehicle and root cause.
Which vehicles are affected by P0718?
Au7o has documented P0718 across 1 vehicle models from 1 manufacturers: Mercedes-Benz.
Join 700+ subscribers following Au7o for vehicle insights and updates.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.