P0911 on Ford: How to Diagnose & Fix
Gate Select Actuator Circuit Range/Performance
1 Ford model · 1 documented issue · 1 critical
P0911 on Ford by model: symptoms, diagnosis and fix
Separate from the clutch shudder that made the PowerShift famous, the DPS6's mechatronic Transmission Control Module - the electronic unit that drives the two shift actuators inside the case - suffers its own solder-joint and internal circuit failures. Failure is usually abrupt rather than progressive: the cluster throws "Transmission Malfunction - Service Now", the car drops out of gear, refuses to shift, or will not move at all, sometimes from highway speed. Clutch actuator control circuit codes (P0902, P090C, P2872, P0910/P0911) are the giveaway. Ford issued Field Service Action 15B22 (TCM reprogramming) and extended TCM coverage to 10 years / 150,000 miles under customer satisfaction programs, which is why so many owners get a TCM replaced at no charge.
Common Symptoms
- Transmission Malfunction - Service Now warning
- Car suddenly will not move or drops out of gear
- Stuck in one gear / limp mode
- No reverse
- Wrench light on dash
How to Fix
Pull the transmission codes before anything else - actuator control-circuit codes point at the TCM rather than the clutch pack. Check for the extended TCM coverage (10yr/150k) and for Field Service Action 15B22 reprogramming by VIN before paying out of pocket. Also inspect the front-of-engine transmission wiring harness (TSB 14-0215) for chafing that mimics TCM failure. The repair is TCM replacement and programming to the vehicle.
Sources for this issue (3)
P0911 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0911 mean on a Ford?
P0911 stands for "Gate Select Actuator Circuit Range/Performance." The gate select actuator circuit is functioning but performance/feedback is out of the expected range — actuator not responding as commanded. On Ford it is documented across 1 model: Focus.
What are the most common causes of P0911?
The most common causes of P0911 are: Failing gate select actuator, Wiring resistance / intermittent fault, Mechanical binding, Internal TCM fault. The specific cause varies by vehicle.
How much does it cost to fix P0911 on a Ford?
Repair costs vary widely with the root cause and Ford model; each issue on this page carries its own estimate where one is published.
Looking for P0911 on a different make?
View P0911 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.