P0902 on 2012-2016 Ford Focus (S, SE, SEL, Titanium) — Clutch Actuator Circuit Low
1 vehicles · 1 makes
How to diagnose and fix P0902: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
Ford Focus · 2012–2016
Separate from the clutch shudder that made the PowerShift famous, the DPS6's mechatronic Transmission Control Module - the electronic unit that drives the two shift actuators inside the case - suffers its own solder-joint and internal circuit failures. Failure is usually abrupt rather than progressive: the cluster throws "Transmission Malfunction - Service Now", the car drops out of gear, refuses to shift, or will not move at all, sometimes from highway speed. Clutch actuator control circuit codes (P0902, P090C, P2872, P0910/P0911) are the giveaway. Ford issued Field Service Action 15B22 (TCM reprogramming) and extended TCM coverage to 10 years / 150,000 miles under customer satisfaction programs, which is why so many owners get a TCM replaced at no charge.
Common Symptoms
- Transmission Malfunction - Service Now warning
- Car suddenly will not move or drops out of gear
- Stuck in one gear / limp mode
- No reverse
- Wrench light on dash
How to Fix
Pull the transmission codes before anything else - actuator control-circuit codes point at the TCM rather than the clutch pack. Check for the extended TCM coverage (10yr/150k) and for Field Service Action 15B22 reprogramming by VIN before paying out of pocket. Also inspect the front-of-engine transmission wiring harness (TSB 14-0215) for chafing that mimics TCM failure. The repair is TCM replacement and programming to the vehicle.
Sources for this issue (3)
Find P0902 by make
Browse every documented model and issue for your make.
P0902 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0902 mean?
P0902 stands for "Clutch Actuator Circuit Low." The clutch actuator control circuit voltage is below the expected range (too low / shorted to ground).
What are the most common causes of P0902?
The most common causes of P0902 are: Actuator circuit shorted to ground, Faulty clutch actuator, Corroded/damaged connector, Internal TCM fault. The specific cause varies by vehicle.
How much does it cost to fix P0902?
Repair costs vary widely depending on the root cause and vehicle.
Which vehicles are affected by P0902?
Au7o has documented P0902 across 1 vehicle models from 1 manufacturers: Ford.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.