U2100ModerateNetwork

U2100 on 2020-2023 Lincoln Aviator — CAN Bus Communication (Manufacturer-Specific)

1 vehicles · 1 makes

Share:@au7o.io

How to diagnose and fix U2100: most-reported vehicles

Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.

Lincoln Aviator · 2020–2023

Some 2020-2023 Aviators equipped with air suspension may display a Drive Malfunction and/or Suspension Fault message with DTCs B1041 and U2100 stored in Suspension Control Module A (SUMA). Ford SSM 51621 says this bulletin-defined condition can occur when SUMA enters diagnostic service mode after an on-demand self-test following suspension diagnosis or repair. It does not identify a leaking air spring, compressor, height sensor, or solenoid as the cause of these two codes.

Common Symptoms

  • Drive Malfunction message
  • Suspension Fault message
  • DTC B1041 stored in SUMA
  • DTC U2100 stored in SUMA

How to Fix

Use Ford Diagnosis and Repair System (FDRS) and select SUMA > Run All CM (Continuous Memory) DTCs. Do not run SUMA > OD and CM DTCs for this condition because the on-demand self-test can create the invalid codes. If that test was run, clear the condition with SUMA > Transport and Factory Mode Deactivation. If other DTCs or physical ride-height symptoms remain, follow Workshop Manual Section 204-05 normal diagnostics before selecting a part.

Owner tips & cautions

  • WarningDo not replace a compressor, air spring, sensor, or solenoid from B1041/U2100 alone; SSM 51621 first corrects a diagnostic service-mode state.
  • TipAsk whether an on-demand SUMA self-test was run immediately before the warning appeared and retain the complete FDRS fault report for any remaining diagnosis.
Sources for this issue (1)

Research This Issue

Manually Verified
High ConfidenceVerifiedUpdated Jul 20, 2026

Find U2100 by make

Browse every documented model and issue for your make.

U2100 code reference

General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.

Frequently asked questions

What does U2100 mean?

U2100 stands for "CAN Bus Communication (Manufacturer-Specific)." U2100 is a manufacturer-specific code indicating a Controller Area Network (CAN) bus communication problem, often meaning one or more modules has gone into a 'bus-off' condition or initial network configuration was not completed. The vehicle's modules talk to each other over the CAN bus, and this code sets when that communication is disrupted. The effect ranges from warning lights to disabled features depending on which modules dropped off.

What are the most common causes of U2100?

The most common causes of U2100 are: Damaged CAN bus wiring (short, open, chafe), Loose or corroded connector at a module (e.g., transmission harness), Faulty control module causing bus-off, Poor or high-resistance ground, Low or unstable battery voltage, Module not configured/programmed correctly after replacement, Water intrusion / corrosion at connectors. The specific cause varies by vehicle.

How much does it cost to fix U2100?

Repair costs vary widely depending on the root cause and vehicle.

Which vehicles are affected by U2100?

Au7o has documented U2100 across 1 vehicle models from 1 manufacturers: Lincoln.

🔧
A mechanic who knows YOUR exact car
Answers tuned to your year, make, model & trim — not generic advice. Save your garage so it always has the right context.
Get notified about U2100 fixes
We add new causes, fixes and affected vehicles for U2100 regularly — drop your email and we'll keep you posted. You can also diagnose your own car free.

Join 700+ subscribers following Au7o for vehicle insights and updates.

Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.