P0335 on GMC: How to Diagnose & Fix
Crankshaft Position Sensor A Circuit Malfunction
1 GMC model · 1 documented issue · 1 critical · $80-$300 repair
P0335 on GMC by model: symptoms, diagnosis and fix
The 4.2L LL8 inline-6 engine in the 2002-2009 GMC Envoy is notorious for crankshaft position sensor failures that cause intermittent stalling and no-start conditions. The sensor is located on the side of the engine block and is exposed to heat soak from the exhaust manifold, accelerating its failure. A failing sensor causes the PCM to lose track of crank position, resulting in the engine cutting out without warning — often at highway speed. The issue tends to be intermittent at first, making diagnosis challenging. Replacement is straightforward and the part is inexpensive.
Common Symptoms
- Engine stalls without warning at any speed
- Hard start or no-start after hot soak
- Check engine light with code P0335 or P0336
- Engine cranks but won't fire when hot
- Intermittent stall that restarts after cooling down
- Rough idle followed by stall
How to Fix
Replace crankshaft position sensor (ACDelco 213-3521 or Delphi SS11378). Clear codes and test. If stalling continues, inspect camshaft position sensor (ACDelco 213-3522) as secondary cause. Verify PCM software is current — older PCM calibrations make the engine overly sensitive to sensor signal dropout.
What you need to fix it
Only diagnosis- and fitment-reviewed repair parts are linked here.
- Engine Crankshaft Position SensorCross-ref235-1078
Fitment confirmed against the ShowMeTheParts catalog for this vehicle's year and engine.
As an Amazon Associate, we earn from qualifying purchases; other part links may also earn au7o a commission. Confirm fitment by VIN before buying.
Sources for this issue (1)
P0335 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0335 mean on a GMC?
P0335 stands for "Crankshaft Position Sensor A Circuit Malfunction." This code means the engine computer has lost or detected a faulty signal from the crankshaft position sensor (sensor A), which tells the computer exactly how fast and in what position the crankshaft is rotating. That signal is essential for timing the spark and fuel injection, so a problem here can cause hard starting, stalling, or a no-start condition. The computer sets this code when the crank sensor signal is missing, erratic, or out of its expected pattern. Causes range from a failed sensor or damaged wiring to a problem with the reluctor (tone) ring the sensor reads. On GMC it is documented across 1 model: Envoy.
What are the most common causes of P0335?
The most common causes of P0335 are: Failed crankshaft position sensor, Damaged, corroded, or loose sensor wiring/connector, Metal debris or oil contamination on the sensor tip, Damaged or misaligned reluctor (tone) ring, Excessive air gap between sensor and tone ring, Wiring shorted or open in the sensor circuit, Faulty PCM/ECM (rare). The specific cause varies by vehicle.
How much does it cost to fix P0335 on a GMC?
Published repair estimates on GMC range from $80 to $300 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for P0335 on a different make?
View P0335 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.