P0345 on GMC: How to Diagnose & Fix
Camshaft Position Sensor Circuit Malfunction (Bank 2)
1 GMC model · 1 documented issue · 1 critical · $80-$300 repair
P0345 on GMC by model: symptoms, diagnosis and fix
The 4.2L LL8 inline-6 engine in the 2002-2009 GMC Envoy is notorious for crankshaft position sensor failures that cause intermittent stalling and no-start conditions. The sensor is located on the side of the engine block and is exposed to heat soak from the exhaust manifold, accelerating its failure. A failing sensor causes the PCM to lose track of crank position, resulting in the engine cutting out without warning — often at highway speed. The issue tends to be intermittent at first, making diagnosis challenging. Replacement is straightforward and the part is inexpensive.
Common Symptoms
- Engine stalls without warning at any speed
- Hard start or no-start after hot soak
- Check engine light with code P0335 or P0336
- Engine cranks but won't fire when hot
- Intermittent stall that restarts after cooling down
- Rough idle followed by stall
How to Fix
Replace crankshaft position sensor (ACDelco 213-3521 or Delphi SS11378). Clear codes and test. If stalling continues, inspect camshaft position sensor (ACDelco 213-3522) as secondary cause. Verify PCM software is current — older PCM calibrations make the engine overly sensitive to sensor signal dropout.
What you need to fix it
Only diagnosis- and fitment-reviewed repair parts are linked here.
- Engine Crankshaft Position SensorCross-ref235-1078
Fitment confirmed against the ShowMeTheParts catalog for this vehicle's year and engine.
As an Amazon Associate, we earn from qualifying purchases; other part links may also earn au7o a commission. Confirm fitment by VIN before buying.
Sources for this issue (1)
P0345 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0345 mean on a GMC?
P0345 stands for "Camshaft Position Sensor Circuit Malfunction (Bank 2)." P0345 means the engine computer detected a malfunction in the camshaft position sensor circuit on bank 2 (the cylinder bank not containing cylinder number one). The camshaft position sensor tells the computer where the camshaft is in its rotation, which it uses for precise fuel injection and ignition timing and to manage cylinder identification. When the signal is missing, erratic, or out of range, the computer can't reliably track cam position, which may cause hard starting, rough running, stalling, or a no-start. The fault is usually in the sensor, its wiring, or the connector rather than the camshaft itself. On GMC it is documented across 1 model: Envoy.
What are the most common causes of P0345?
The most common causes of P0345 are: Failed camshaft position sensor (bank 2), Damaged wiring, connector, or corrosion in the sensor circuit, Metal debris or oil contaminating the sensor tip, Faulty reluctor/tone wheel on the camshaft, Open or short in the sensor signal or power circuit, Loose timing chain/belt or VVT issue affecting cam timing, Poor ground or low reference voltage to the sensor. The specific cause varies by vehicle.
How much does it cost to fix P0345 on a GMC?
Published repair estimates on GMC range from $80 to $300 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for P0345 on a different make?
View P0345 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.