P0730 on GMC: How to Diagnose & Fix
Incorrect Gear Ratio
1 GMC model · 1 documented issue · 1 critical · $300-$4,500 repair
P0730 on GMC by model: symptoms, diagnosis and fix
The Allison 1000 (gas) and Allison 2000 (diesel) 6-speed automatic transmissions used in Sierra 2500HD/3500HD are widely regarded as extremely durable, but the Transmission Control Module (TCM) and solenoid pack do develop faults. Common issues include harsh 1-2 shifts, transmission sticking in one gear, slip codes, and the truck going into limp mode (3rd gear only). The Allison's proprietary Transynd fluid is critical — using non-approved fluid is the leading cause of premature solenoid wear. TCM software updates from GM address most calibration-related shift complaints.
Common Symptoms
- Harsh or clunky 1-2 upshift
- Transmission stuck in 3rd gear (limp mode)
- Delayed engagement from Park to Drive
- Slip or flare during 2-3 shift
- Check engine light with transmission codes (P0700, P0730, P0751)
- Transmission not shifting above 3rd gear under load
How to Fix
TCM software update at dealer. Allison Transynd fluid service (drain/fill every 30k miles, full exchange every 60k). Solenoid pack replacement (Allison 29539579). TCM replacement if software update fails. Always use genuine Allison Transynd TES-295 or Mobil Delvac 1 ATF — not GM DEXRON products.
Sources for this issue (1)
P0730 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P0730 mean on a GMC?
P0730 stands for "Incorrect Gear Ratio." This code means the transmission computer detected that the actual gear ratio (calculated from input vs. output shaft speeds) does not match what it should be for the commanded gear. In other words, the transmission isn't delivering the correct gear, which often shows up as slipping, flaring RPM during shifts, or being stuck in the wrong gear. It can stem from internal mechanical wear, low or contaminated fluid, or faulty solenoids and sensors. The vehicle may shift harshly or enter limp mode. On GMC it is documented across 1 model: Sierra 2500HD.
What are the most common causes of P0730?
The most common causes of P0730 are: Low or contaminated transmission fluid, Worn clutches or bands (internal slipping), Faulty shift solenoids, Dirty or sticking valve body, Faulty input or output speed sensor, Internal hydraulic/line pressure problems, Torque converter problems, General high-mileage transmission wear. The specific cause varies by vehicle.
How much does it cost to fix P0730 on a GMC?
Published repair estimates on GMC range from $300 to $4,500 depending on the model and root cause. If an issue mentions a recall or campaign, check your VIN with the manufacturer or NHTSA and confirm eligibility and coverage with a dealer.
Looking for P0730 on a different make?
View P0730 across all makes →Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.