P2600 on 2012-2018 BMW 6 Series (640i, 640i xDrive, 640i Gran Coupe) — Coolant Pump "A" Control Circuit/Open
1 vehicles · 1 makes · $900-$3,300 repair
How to diagnose and fix P2600: most-reported vehicles
Ranked by owner reports. Each card gives the symptoms, how to confirm the cause, the fix, parts and sources for that vehicle.
BMW 6 Series · 2012–2018
The 2012-2018 640i uses the N55 inline-six with an electric main coolant pump that is a known wear item across every N55 application. On 6Post, 640i owners report failures around 60,000-100,000 miles: sudden high-temperature warnings, reduced-power mode, the pump running continuously after shutdown, or a stored coolant-pump fault. Because the pump is electronic it usually fails without the whining or weeping a mechanical pump gives, and overheating can follow quickly. The V8 650i's N63 does not share this pump.
Common Symptoms
- Engine temperature warning / overheating
- Reduced engine power message
- Water pump runs continuously after shutdown
- Coolant pump fault stored in DME
How to Fix
Replace the electric water pump together with the thermostat (they are usually done as a set). Genuine pump is $500-$600; independent shops charge roughly $900-$1,300 all-in while dealer estimates for a 640i run $1,900-$3,300. Many owners replace preventively around 80,000 miles. No recall for the main pump itself.
Sources for this issue (3)
Find P2600 by make
Browse every documented model and issue for your make.
P2600 code reference
General diagnostic-code context. The code alone does not confirm a cause for your vehicle; use the applicable issue card and its sources.
Frequently asked questions
What does P2600 mean?
P2600 stands for "Coolant Pump "A" Control Circuit/Open." The PCM commands the auxiliary/electric coolant (water) pump 'A' but detects an open in its control circuit — essentially no electrical continuity, as if a wire were cut, a connector unplugged, a fuse blown, or the relay failed. The pump cannot be driven, so the module sets this code.
What are the most common causes of P2600?
The most common causes of P2600 are: Open or broken wiring in the coolant pump control circuit, Corroded, loose, or unplugged pump connector, Failed coolant pump relay or blown fuse, Failed electric coolant pump (internal open winding), PCM driver circuit fault. The specific cause varies by vehicle.
How much does it cost to fix P2600?
Repair costs for P2600 range from $900 to $3,300, depending on the vehicle and root cause.
Which vehicles are affected by P2600?
Au7o has documented P2600 across 1 vehicle models from 1 manufacturers: BMW.
Content compiled with AI assistance using NHTSA complaints, TSBs, and owner reports. May contain errors. Always verify with your vehicle's service manual.